My vehicle does not have a shoulder bolt anchor point. Step # 3: Now insert the replacement Shoulder Bolt (7/16" fine thread Grade 5 or better) through the hole in the Shoulder Sash (B) End of your new replacement seat belt and screw the bolt into the existing anchor point that is located on the upper door post as seen in Fig.
(The hex bolt should be firmly tightened.) You can replace the bolt with a new replacement one purchased from Wesco and found in our 3 point retractable Replacement Seat Belts Optional Hardware Kit (part # 3pt-rmk) or the hex bolt (7/16" fine thread Grade 5 or better) from the old seat belt if the car has never been in an accident. Replacement: Insert the hex bolt through the (A) Retractor End of your new Wesco replacement seat belt and then screw the hex bolt into the existing anchor point (threaded hole) located on the outboard side of the vehicle near the floor as shown in Fig. Step # 1: To begin replacement, remove the existing seat belt that you are replacing including the long side of harness on the outboard side (towards the door, between the seat and the side of the vehicle) and the short side of the seatbelt on the inboard side.
Not for replacement use in aircraft or racing competition. These instructions apply only to retractable seat belts from Wesco, not to be used with replacement seat belts from other manufacturers or retailers. Replacement Seat Belt 3 point formerly, #welr, FMVSS Federal Safety Approved Retractable Belt: CAUTION: Read these seatbelt instructions for 3 point retractable replacement seat belts thoroughly before installing this replacement safety harness.